A printed circuit board (PCB) mechanically supports and electrically connects electronic components using conductive tracks, pads and other features etched from copper sheets laminated onto a non-conductive substrate. Components-capacitors, resistors or active devices-are generally soldered on the PCB.

Today, many of our daily appliances and equipment use electronics, sensors and sophisticated computer technologies. Circuit Designing & PCB Designing is an integral part of any Electronic Gadget or Robotics. If you know how to design any circuit & logic behind it then you can do any innovation with your creative ideas.

You might be surprised at what you can design - you just have to have a 'problem' to utilize your knowledge. Even with some basic knowledge you can do some pretty cool things. A lot can be done with some transistors, op amps and logic gates.

See how by taking little steps you can create your own circuit? It may not be a super-dooper all-singing all-dancing circuit with a hundred ICs and crystals and bluetooth and all that stuff, but it's a circuit that you have made.

Topics to be Covered in this Workshop

Session I: Introduction to Basic Electronics

Session II: Introduction to Circuit Designing (My First Circuit)

Session III: PCB Designing

Session IV: PCB Etching & Drilling

Session V: Components Soldering

Session VI: Project Testing (Final Testing of 'Solar Powered Multi Level Water Tank Alert Circuit'.)


Session VII: Quiz & Competition

At the end of the workshop a small competition will be organized & winning team will get the certification of excellence.

Certification Policy

1. Certificate of Merit for all the workshop participants SAW RESEARCH & DEVELOPMENT.

2. At the end of this workshop, a small competition will be organized among the participating students and winners will be awarded with a 'Certificate of Excellence'.

3. Certificate of Coordination for the coordinators of the school workshops.


The duration of this workshop will be two consecutive days, with 6-7 hours session each day in a total of 12-14 Hours.


The pre-requisite for joining this workshop is zero.

Request for Details